Initial operation – TechniSat 100Hz Television sets Colani-TV Classic Line User Manual

Page 3

Advertising
background image

➫ Connect to power supply 230V/50Hz AC

➫ The TV set is designed to receive and reproduce

only sound and video signals.

➫ The set is designed to be connected only to audio

and video equipment, antenna installations and
computers that comply with DIN standards, and
carry a CE certification.

➫ The set may be used for private and commercial

purposes, and must be operated inside a dry
room, and under supervision.

➫ Any other form of operation is specifically exclu-

ded.

This equipment complies with the following stan-
dards:
Radiation (X-Ray) regulations (RöV in Germany) of
08.01.1987,
EU guideline 73/23/EEC (low-voltage regulations)
- EN 60065
EU guideline 89/336/EEC (EMV guideline)
- EN 55013, EN 55020, EN 60555-2
And carries CE certification.

Spent batteries should not be discarded with dome-
stic refuse. They can either be disposed of by sepa-
rate channels, or they will collected by the dealer.

Should the TV set reach the end of its lifespan after
many years, specialist retailers will take it back for
environmentally-friendly disposal

TechniSat provides a coupon for an old TV set when
you purchase a new set.

The housing of a Colani-Line set can be cleaned with
a soft, slightly moist cloth.
The housing of a Classic Line set can be cleaned
with a soft, dry cloth.
Do not use spray cleaners or any aggressive chemi-
cal detergents for the housing, as this may damage
the high-quality surface.
The screen can be cleaned while the set is switched
off, using a dry or very slightly damp cloth.

➫ If the following safety precautions are ignored, the

manufacturer's responsibility ceases.

Never open the housing!

It is extremely dangerous to touch parts carry-
ing high-voltage current.

➫ Only trained personnel may carry out repairs.

➫ Should the set be delivered or transported during

cold weather, do not switch it on immediately, but
allow the set to adjust to room temperature first.

➫ Operate the set in an environment where it is safe

from humidity and damp, as well as splashes or
drops of water. If water gets into the housing,
immediately disconnect the power supply and call
a service technician.

➫ Do not place the set in very confined bookshelves

or cupboards, and allow at least 10cm space all
round for ventilation.

➫ Do not place the TV set near a heater or other

equipment that will cause the set to heat up more
than usual.

➫ Do not expose the set to strong sunlight, and

never cover up the ventilation slots, as this would
affect the cooling of the set.

➫ In case of electrical storms, disconnect both the

antenna and power connections, as power surges
can damage the set.

➫ Do not stick any objects into or through the ventila-

tion slots.

➫ If you notice a specific defect, or if there is a stran-

ge smell and smoke coming from the set, dis-
connect the power supply immediately, and call a
technician.

➫ If you are out of the house for an extended period

of time, the TV set should be switched off. This
saves energy, and prolongs the lifespan of the pic-
ture tube.

➫ If the set is kept in standby mode via the remote

control, power consumption is approximately 1
Watt.

Operating the equipment correctly

Manufacturer’s declaration

Safety advice

Disposal advice

Cleaning and care

2

Initial Operation

Advertising