Yamaha PSR-330 - Manual (Page 40)

38
,,,,,,,,,,,,,,,,
,,,,,,,,,,,,,,,,
QQQQQQQQQQQQQQQQ
QQQQQQQQQQQQQQQQ
Transpose
This functions allow the overall pitch of the PSR-330 to be transposed up or down by a
maximum of one octave in semitone increments.
Setting Transposition
Use the TRANSPOSE [▼] and [▲] buttons to set the desired degree of transposi-
tion. Press either button briefly to decrement or increment by one, or hold for
continuous decrementing or incrementing. The current transpose value will appear on
the top line of the display for a few seconds whenever one of the TRANSPOSE buttons
is pressed — during this time the [–] and [+] buttons or number buttons can also be
used to set the transpose value (the transpose value also appears continuously above
“TRANSPOSE” in the display).
• Press the TRANS-
POSE [ ▼ ] and [ ▲ ]
buttons simulta-
neously to instantly
reset the transpose
value to “0”.
• The new TRANS-
POSE value will take
effect from the next
key played.
• The TRANSPOSE
value cannot be
changed during song
playback or while the
record mode is en-
gaged.
The transpose range is from –12 to +12. Each step corresponds to one semitone,
allowing a maximum upward or downward transposition of 1-octave. A setting of “0”
produces the normal pitch.
-02
VOICE L VOICE R2 VOICE R1 46 51 1
Transpos
REVERB TRANSPOSE
2 -
REPEAT
TRANSPOSE