Topcom DIABLO 150 User Manual
Page 4
4
Topcom Diablo 150/Twin/Triple/Quattro
Topcom Diablo 150/Twin/Triple/Quattro
4
Battery low indication
When the battery is empty, the handset no longer carries out operations. When a battery is completely
empty and you have put the handset on the base unit for a short period of time, the Battery symbol will
appear to be fully charged but this is actually not the case. The battery capacity will decrease rapidly.
We advise you to put the handset on the base unit for 12 hrs so that it can be recharged completely:
Full battery
Empty battery
When you are in the middle of a conversation and the battery is almost empty, the handset will emit a
warning signal. Place the handset on the base unit to charge.
5
Operation
5.1
Outgoing calls
5.1.1 Making a phone call or redialing the last number
Press the Off-hook button
. You will hear the dial tone.
Î
Enter the desired telephone number or
press the Redial key
to dial out the number you last called.
Î
Press the on-hook button
when
you want to terminate the call.
5.1.2 Call setup with dial preparation
Enter the desired telephone number. An incorrect number can be corrected by means of the Mute
button.
Î
Press the Off-hook button
. The number will be dialled automatically.
Î
Press the On-
hook button
when you want to terminate the call.
5.1.3 Redial one of the last 5 numbers dialled
Press the Redial key .
The
number you last called appears on the display. If you would like to dial one
of the last 5 numbers dialled, press the scroll keys
a few times until the desired number appears
on the display.
Î
Press the Off-hook key .
Î
The number shown on the display is dialled
automatically.
Î
After finishing your call, press the On-hook key
to
hang up.
5.2
Incoming calls
When a call comes in, the handset will start to ring.
Î
Press the Off-hook button
to answer the
incoming call. To end the call press the On-hook button.
5.3
Programming memory numbers
You can program 10 indirect numbers (of max. 24 digits) in the phone’s memory.
Press the Memory
button short. The first entry will be shown on the display
Î
Press and hold the
Memory button
until the
-icon appears on the display.
Î
Enter the location (0-9) where you want
to store the telephone number under.
Î
Enter the telephone number you whish to store.
Î
Press
the Memory button
again to confirm.
Î
You will hear a confirmation tone and the next entry will
appear. To leave the memory programming, press the on-hook
button.
5.4
Calling a memory number
Press the Memory button
Î
Scroll with the Up/Down keys
to the entry you want to dial (0-9).
Î
Press the Off-hook button
. The memory number will be dialled automatically.
Î
Press the On-
hook button
to terminate the call.
If you wish to insert a pause, press the Redial/Pause button
on the location where
you want a pause of 3 sec.
/P