Toshiba e-studio 5520C - Manual (Page 26)

1 TROUBLESHOOTING FOR THE HARDWARE
24 Clearing a Paper Jam
5 If the paper size is small, turn the knob shown in the following figures to send the
paper, and then check that no paper is jammed.
1) Turn the knob to feed the paper.
When the Hole Punch Unit is installed, open the front cover of the Finisher and turn the 2 knobs at the same
time.
2) Remove the jammed paper if it comes out.
6 Close the Hole Punch Unit cover when it is installed.
7 Remove the paper jammed in the equipment side.
1
2
When the Hole Punch Unit is not installed When the Hole Punch Unit is installed