Tekram Technology DC-315 Series - Manual (Page 2)

DC-315 Series User’s Manual
2 2
1. INTRODUCTION
The DC-315 series is a SCSI (Small Computer System Interface) bus to PCI bus host adapter,
which complies to the PCI 2.1 specification with Plug-&-Play (PnP) readiness. By using the
Disconnect/Reconnect technique, performance degradation during multitasking operations is
prevented. Other enhanced SCSI-2 features such as scatter-gather and command-tag queuing
are supported.
The DC-315 series supports ASPI (Advanced SCSI Programming Interface) managers for the
following operating systems to assure operation with popular third party applications:
•
MS-DOS
•
Windows 95/98/NT
Device drivers are also supported for the following major operating systems for
compatibility with a full range of SCSI peripherals including CD-ROMs, Photo CDs, tape
backups, scanners, removable media and SCSI hard drives:
•
MS-DOS
•
Windows 95/98
•
Windows NT 3.x/4.0
2. HARDWARE SETUP
Static Precautions
Static electricity can be a serious danger to the electronic components on this board. To avoid
damage caused by electrostatic discharge, observe the following precautions:
ü Don’t remove the board from its anti-static packaging until you are ready to install it into
a computer case. Also, handle add-in cards and modules by the edges or mounting
bracket.
ü Before you handle the board in any way, touch a grounded, anti-static surface, such as an
unpainted portion of the system chassis, for a few seconds to discharge any built-up static
electricity.
Before plugging the DC-315 series adapter into your system, make sure that the SCSI ID
number (0-6 for DC-315/315U) of each SCSI device is set properly for the host adapter.
The maximum devices that can be installed on each model are show below:
Model # Max. Devices Number
DC-315 7
DC-315U 7