Toshiba SURVELILLIX HVR32-X - Manual (Page 53)

35
MOTION SETUP
The DVR allows the user to adjust several different Motion Settings and create motion detection regions.
NOTE: Motion grids configured using the SCS software will be advanced motion grids.
Creating a Motion Area
1. Click the Motion button in Setup.
2. Select a camera from the Select Camera list.
3. Select the Detect Detail Motion Area check box.
4. Click Clear.
5. Click Advanced Motion Area Setup.
6. Click a Motion Detection Area shape button.
7. Drag the mouse over the camera image.
TIP: To create a polygon shape, click the mouse at each point and
double-click to close the shape.
8. Click OK.
9. Move the sliders to adjust motion sensitivity and the noise filter.
10. Define the pre-alarm and post-alarm recording time for a motion
event.
Pre Alarm – 0 > 50 Seconds [The number of seconds the DVR
records before motion is detected]
Post Alarm (MOTION) – 0 > 50 Seconds [The number of seconds
the DVR records after motion is detected]
Schedule recording at a regular specified interval
Display full screen video
pop up on motion event
Beep on motion event
Display full screen video
pop up on sensor event
Reduces Analog Signal Noise from Motion Detection