TOA Electronics C-CV24-2 NTSC - Manual (Page 5)

5
13
8
13
10 13
8
30 mm
20 mm
Camera direction
Camera mounting hole
Camera outside diameter
Ø118 mm
Cable entry hole
Ø35 mm
Cut out using a pair of nippers.
5. INSTALLATION
5.1. Coaxial Cable Preparation and Termination
3C-2V Type
1. Strip the cable jacket 13 mm from the cable end.
2. Fold back the shields over the cable, then strip the insulator 8 mm from the
cable end.
5C-2V Type
1. Strip the cable jacket 23 mm and the shields 13 mm from the cable end.
2. Strip the insulator 8 mm from the cable end.
7C-2V Type
Connect an intermediate length of 5C-2V cable between the end of the 7C-2V
cable and the camera.
5.2. Installation
1. Determine the installation method.
1-1. Unexposed wiring
Using the installation hole gauge, make a
cable entry hole in the ceiling.
1-2. Open wiring
Cut out the thin camera section shown below
using a pair of nippers.