Toastmaster WST7503 - Manual (Page 10)

9
DISASSEMBLY/REASSEMBLY DIAGRAM
Water Basin
(P/N 40272)
Water Tank
Handle
Water Tank Lid
Main Housing
Wick
Filter
Holder
Cool Mist
Outlet/
Cover
1. Remove
Water Tank
2. Press Release
Button on Side
Panel
4. Pull Cool Mist
Main Body
straight up and
off Water Basin
3. Press Release
Button on Side
Panel
Figure 4
Your Humidifier is operated directly from the Control Panel located on the top of
the unit. Timer Set, Fan speed, remaining time, current room humidity, preset
humidity level: are all shown on the LCD Display.
1. Plug the Cool Mist Humidifier into a 120V AC electrical outlet. The current
room humidity will illuminate.
2. Press the ON / OFF Button to turn the unit ON.
3. The Cool Mist Humidifier displays current humidity and the previously preset
humidity. When the current humidity level is less than the preset humidity
level, a fine mist will moisten the air until the preset humidity level is reached.
The Humidifier will automatically cycle ON and OFF as it maintains the proper
humidity level.
NOTE: Make sure the front of the Cool Mist Outlet is at least 6 feet 6 inches from
the nearest wall.
NOTE: If the current room humidity is greater or equal to the preset humidity level,
the unit will not operate.
NOTE: If the water droplet appears on the LCD Display, check the water level in the
Water Tank and refill if necessary. It is recommended that the Water Tank be
refilled BEFORE it runs completely empty.
4. Press the ON/OFF Button again to turn the unit OFF.
6
CONTROL PANEL
ON/OFF/FAN TIMER
LCD DISPLAY Safety Auto Shut Off /
Refill Water
Timer Set
Fan
Fan Speed:
Lo, Med, Hi
Current
Room
Humidity Preset
Humidity
Level
OPERATING INSTRUCTIONS
Figure 2
Figure 3