Toshiba B-850 - Manual (Page 77)

APPENDIX 4 SYSTEM MODE EO1-33029
A4.1 Operation Panel
A4- 1
APPENDIX 4 SYSTEM MODE
A4.1 Operation Panel
Appendix 4 describes usage and purpose of the keys on the Operation
Panel in System Mode.
For end users, System Mode should be used for the following four
purposes:
•
To check and print the system status, the Maintenance Counter, and
the Print Head Element.
•
To make fine adjustment related to the media issue.
•
To perform a test print for checking print quality.
•
To set the parameters for the PCL Emulation.
The figure below illustrates the Operation Panel and key functions.
The LCD Message Display shows messages in alphanumeric characters
and symbols to indicate the printer’s status. Up to 16 characters can be
displayed on one line.
There are three LEDs on the Operation Panel.
LED Illuminates when…
POWER The printer is turned on.
ON LINE The printer is ready to print.
ERROR Any error occurs with the printer.
In System Mode, the [FEED], [RESTART] and [PAUSE] keys
function as described below.
FEED
Used to start the system mode as a [RESTART] key
does. Used to select the parameter mode or to fine
adjust the parameters in the negative direction (-).
RESTART
Used to select the parameter mode or to fine adjust
the parameters in the positive direction (+).
PAUSE
Used to start the system mode as a [FEED] key does.
Used to select the parameter mode. Used as an enter
key.
POWER ONLINE ERROR
FEED RESTART PAUSE
IMPORTANT !
If System Mode is needed for
any other purposes, please
contact a TOSHIBA TEC
authorized service
representative before
performing any operation in
System Mode.
LCD Message Display
ON LINE LED (Green)
ERROR LED (Red)
[PAUSE] key
POWER LED
(Green)
[FEED] key
[RESTART] key
NOTE:
Use the [RESTART] key to
resume printing after a pause
condition, or after clearing
an error.