Tyan Computer TIGER S5350 - Manual (Page 49)

Tiger i7320 S5350 Chapter 3: BIOS Setup
3-21
http://www.tyan.com
3.6 Power
These settings allow you to configure the power options for your system.
Resume On Time
When enabled, this allows the system to be woken up at a specified time. This time is
specified by the Resume Time parameter.
Off / On
Power Button Behavior
This specifies the behavior of the system after the power button is pressed.
• On/Off - This powers on / powers off the system after the power button is pressed.
• Wake/Sleep - This wakes the system from/puts the system to sleep.
After Power Failure
Specifies the mode of operation after the system recovers from a power loss.
• Enabled: This restores the system to the last state it was in before the power loss
occurred.
• Disabled: This keeps the power switched off till the power button is pressed.
Chassis Intrusion Detect
Enable/Disable: when chassis open event is detected, BIOS will record the event.
Enabled / Disabled
Power On by PCI/PCI-X card
An input signal from PME on the PCI card awakens the system from a soft off state.
Enabled / Disabled