Transition Networks Substation-Rated Industrial Ethernet SUBTF10XX-1XX-MX - Manual (Page 5)

8
SIBTF10xx-1xx-Mx
24-Hour Technical Support: 1-800-260-1312 International: 00-1-952-941-7600
Installation -- continued
DIP switch settings
1. Port 1 copper Auto-Negotiation:
UP (Enabled) - Advertises switch speed and mode
capabilities to the network:
• 100Mb/s full-duplex • 100Mb/s half-duplex,
• 10Mb/s full-duplex • 10Mb/s half-duplex.
DOWN (Disabled) - Does not advertise switch speed
and mode capabilities to the network. With Auto-
Negotiate disabled switches 2 and 3 are used to set the
twisted-pair speed and mode.
2. Port 1 copper speed:
UP (100Base-TX) - Sets the twisted-pair speed to
100Base-TX.
DOWN (10Base-T) - Sets the twisted-pair speed to
10Base-T.
3. Port 1 copper duplex:
UP (Full-Duplex) - The twisted-pair cable distances
are constrained by the cable requirements.
DOWN (Half-Duplex): - The twisted-pair cable
distances are constrained by the 512-Bit Rule.
4. Fiber port FX 1 duplex:
UP (Full-Duplex) - The cable distances for the fiber
port are constrained by the cable requirements.
DOWN (Half-Duplex) - The cable distances for the
fiber port are constrained by the 512-Bit Rule.
5. Fiber port FX 2 duplex (model 130 only):
UP (Full-Duplex) - The cable distances for the fiber
port are constrained by the cable requirements.
DOWN (Half-Duplex) - The cable distances for the
fiber port are constrained by the 512-Bit Rule.
1
Auto-Negotiation Dis abled
Auto-Negotiation E nabled
2
10Bas e-TX
100Bas e-TX
Half Duplex
Full Duplex
3
Half Duplex (fiber)
Full Duplex (fiber)
4
Half Duplex (fiber)
Full Duplex (fiber)
5
[email protected] -- Click the “Transition Now” link for a live Web chat. 9
Installation -- continued
6. Link Pass-Through (model 110 only):
UP (Enable) - When Link Pass-Through is enabled, a fault
on one side of the switch stops the signal and data
transmission on the other side. See the detailed explanation
of Link Pass-Through on page 18.
DOWN (Disable) - When Link Pass-Through is disabled, a
fault on one side of the switch does not stop the signal and
data transmission on the other side.
Link Pass- Through Disabled
Link Pass- Through E nabled
6
7. Fiber redundancy (model 130 only):
UP (Disable) - When fiber redundancy is disabled, the
two fiber ports (1 and 2) act as normal bridging ports.
DOWN (Enable) - When fiber redundancy is enabled,
the two fiber ports (1 and 2) are configured as
forwarding or disabled. At any given time one port will
be disabled and one port will be forwarding.
8. AutoCross:
UP (Enable) - The switch will connect to a straight-
through or a crossover twisted-pair copper cable
automatically.
DOWN (Disable) - In the down position the straight-
through or crossover twisted-pair copper cable must be
installed according to the site requirements.
Redundant Fiber Dis abled
Redundant Fiber E nabled
7
AutoCross Disab led
AutoCross E nabled
8