Technicolor - Thomson DPL580HT - Manual (Page 16)

Operating Your Receiver
EN
13
Switching the unit on and off
• To switch on the receiver, press the ON/ECO button
on the main unit once, or the button on the
remote control.
• Standby: when the receiver is in tuner mode, press
the ON/ECO button once to enter standby
mode.
On the remote control, press the button twice
within 2 seconds if the receiver is not in Tuner source
mode to enter standby mode.
To avoid entering standby mode when powering up
the unit, do not press the
button twice within 2
seconds.
• The receiver draws a small amount of electricity when
in standby mode. Unplugging the unit from the wall
socket will stop the draw.
Selection of Audio/Video source
When one of the source button is pressed, the audio
and video input corresponding to the name will be
activated.
The receiver acts as a switching device between all the
sources that are plugged into it.
Example 1:
If you have connected a DVD player to the DVD input
(audio + video) on the receiver, press the SOURCE
buttons on the main unit repeatedly until DVD is
selected or press DVD•6CH on the remote control to
receive the sounds and images transmitted by the
DVD.
Example 2:
Based on the example 1, the DVD is playing , if a VCR
is connected to the VCR input (audio + video) of the
receiver, press the SOURCE buttons on the main unit
repeatedly until VCR is selected or press AUX 1 (VCR)
on the remote control. The image and sound from the
VCR source will replace the DVD.
B_DPL580 EN 4/16/04 12:53 PM Page 17