Tripp Lite B022-U16KVM - Manual (Page 6)

6
4. OSD (On-Screen Display) Operation
4.1 OSD Overview
The On-Screen Display (OSD) is a text-based interface that allows for control and
administration of the KVM switch. When logging onto the KVM switch, the OSD Main
Menu is the first screen you will see after entering your username and password.
4.2 Logging In For The First Time
The KVM switch features a two-level security, with one Administrator and four User
accounts. If you are an Administrator accessing the KVM switch for the first time, leave
the username and password field blank and hit the [Enter] key twice to access the OSD
Main Menu. Once logged into the KVM switch as Administrator, you will be able to access
all OSD features and customize KVM settings. At this point, it is highly recommended that
you change the Administrator username and password.
3. Basic Operation
3.1 Opening the NetDirector Console KVM
3.2 Closing the NetDirector Console KVM
The console is located under the top cover.
To access the console, slide the console
module out and raise the cover.
Note: As a safety precaution, to keep the console from
accidentally sliding out, the console is locked into the in
position. Before you can pull the console module out, you
must release it by pushing the catches on the unit’s front
panel toward the center of the switch.
To slide the console module back in, close
the cover and do the following:
Pull the safety catches on the unit’s side 1.
rails toward you and push the module in
until it stops.
Release the catches; pull the module
2.
slightly toward you; then push it all the
way in.
Note: The reason for the two-step procedure is to
minimize the chances of pinching your fingers when
sliding the module in.
201005078 93-2901.indd 6 5/17/2010 4:35:48 PM