Australian Monitor ACM1202P - Manual (Page 2)

Product Description
The ACM1202P is a dual 120 watt power amplifier designed for commercial installations. The one unit contains two
independent 120 watt amplifiers for either stereo or dual zone applications. The ACM1202P can be used for either low
impedance (4 or 8 ohm) or 70v/100v line speaker systems per channel. The amplifier can be mounted in a standard 19”
equipment rack (rack ears supplied) or it can be used on a shelf or table. The ACM1202P features a line level input (with
parallel output) per channel and is normally used with mixers, mixer amplifiers or other power amplifiers.
ACM1202P, 2 x 120 Watt Power Amplifier
Front Panel Features
Power Switch
The black rocker switch on the right hand side of the front panel is used to switch the amplifier on and off. The ‘up’
position is on. When the amplifier is connected to an appropriate AC power source and is switched on, the blue power
LED will illuminate.
On LED
The blue “On” LED above the power switch will illuminate when the amplifier is connected to mains power and is
switched on.
Signal LED
The green “Signal” LED’s located next to the On LED indicate that the ACM1202P is receiving audio signal via its line
level inputs. One LED is provided per channel. The signal LED’s are a simple way of trouble-shooting installations
especially in multi amplifier projects. At a glance the signal LED’s will indicate that audio is reaching the amplifier.
Rack Mounting
The ACM1202P is supplied with rack ears attached to allow mounting within a standard 19” equipment rack. As is the
case with almost all audio products, adequate ventilation and air flow is required. When installing multiple ACM
amplifiers within the one rack, it is recommended that at least one rack unit of ventilation space is left between every two
amplifiers.
For table or shelf mounting, the rack ears can be removed using a screwdriver. Once the rack ears are removed, please
reinstall the screws.
POWER
ON SIG NAL
1 2