Tally Genicom 6600 - Manual (Page 98)

98
Chapter 5 Repeating Data, Version 1
Repeating Data, Version 1
Horizontal Repeat
Horizontal Version 1 repetition can be accomplished by bracketing the
commands and data to be repeated with the commands shown below:
Command ^Snntt^-<data>^-^S^-
Arguments
^S Version 1 Horizontal Repeat Command
nn Number of times to repeat (00 to 99).
tt Number of 0.10 increments to move after each
repeat.
<data> Data to be repeated.
^S^- Version 1 Horizontal Repeat Terminator.
NOTE: Auto increments/decrements are not supported within a Version 1
horizontal repeat.
Example: The command sequence, ^S0225^-^M0202Horz^_^S^- prints:
Vertical Repeat
Vertical Version 1 repetition can be accomplished by bracketing the
commands and data to be repeated with the commands shown below:
Command ^Rnnnn^_<data>^-^Z^-
Arguments
^R Version 1 Repeat Command
nnnn Number of times to repeat (0000-9999)
<data> Data to be repeated.
^Z^- Version 1 Vertical Repeat Terminator.
Example: The command sequence ^R0003^-^M0202Vertical Repeat^-^-
prints:
NOTE: Version 1 Vertical Repeats may be nested only two levels deep (i.e.,
an outer repeat and an inner repeat).