Troy-Bilt TB672 - Manual (Page 6)

Assembly & Set-Up
3
6
NOTE: This Operator’s Manual covers several models. Jet sweep
blower features may vary by model. Not all features in this
manual are applicable to all models and the jet sweep blower
depicted may differ from yours.
NOTE: All references to the left or right side of the jet sweep
blower are from the operator’s position. Any exceptions will be
noted.
Assembly
Attaching the Upper Handle
Remove the carriage screws and star knobs from the upper 1.
holes in the lower handle. See Fig. 3-1.
Place the upper over the lower handle, aligning the upper 2.
holes/metal tabs in the upper handle with the upper holes/
lower holes in the lower handle. See Fig. 3-2.
Secure with the carriage screws and star knobs removed 3.
earlier. See Fig. 3-2.
Figure 3-1
Contents of Crate
One Jet Sweep Blower • One Upper Handle • One Chute Attachment •
One Jet Sweep Blower Operator’s •
Manual
One Engine Operator’s Manual •
Figure 3-2