Thermaltake EPS 12V - Manual (Page 4)

-Tough Atomic Energy
Build for the Extreme-
-Tough Atomic Energy
Build for the Extreme-
ATX 12V 2.2 & EPS 12V Version ATX 12V 2.2 Version & EPS 12V
05 04
3.
Installation
3.1.1 Do not pull the AC power cord when the power supply is in
use or else damage to components will result.
3.1.2 Do not store the Power Supply in a high humidity and high
temperature environment.
3.1.3 When using an ATX type power supply under testing
conditions where the power supply unit is not installed in a
PC with its components, please follow the steps below:
1)Please take a paper clip and untwist it.
2)Make sure the power supply unit is in the "OFF" position.
3)Locate the 20 or 24 pin motherboard connector from the
power supply unit.
4)Plug one side of the paper clip into the green wire hole.
5)Plug the other side of the paper clip into any of the black
wire holes.
6)Turn on the PSU to see if the power supply fans turn on.
3.1.4 High voltages exist in the power supply. Do not open the
power supply case unless you are an authorized service
technician or electrician.
3.1.5 All warrantees and guarantees shall be voided should there
be a failure to comply with any of the warnings and cautions
covered in this manual.
3.1 Warnings and Cautions
2.
Components Check
1
2
750W power supply unit
Mounting screws 3
One AC Input power cord
Toughpower 750W Toughpower 750W
4 User manual
170 X 140 mm