TOYOTA TY-71-00-G3 - Manual (Page 2)

TOYOTA TUNDRA 2000-2006
TOYOTA SEQUOIA 2001-2007
(AUTOMATIC CLIMATE CONTROL ONLY)
PART NUMBER: TY-71-00-G3
PLEASE READ COMPLETE INSTRUCTIONS BEFORE INSTALLING THIS VSM G3
All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling
wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break.
#2 Phillips screwdriver, hook tools, 5/64” drill bit and drill, Dash Trim Removal Tool (DTRT),
marking pen.
VSM G3, A Plate, J Stem, two (2) #8 1/2” screws
Right of air vent TOOLS REQUIRED:
PARTS INCLUDED:
LOCATION:
STEP 1. Push the top of the left and right air vents
into the dash, exposing two (2) Phillips screws, (See
top picture). Remove the screws. There are five (5)
retainer clips that hold the radio bezel in place.
They are located at top center, left and right middle
and the remaining two (2) on the bottom of the
bezel. Using a DTRT, gently twist to release the
clips and remove the bezel. Set the bezel aside.
STEP 2. Locate the flat section of plastic to the
right of the right air vent, (See middle picture).
Place the VSM G3 over this section of plastic, making
sure that the bottom of the VSM G3 is level. Once
the G3 is in position, mark two (2) spots for drilling
pilot holes using the two (2) holes in the G3 as a
guide. Set the mount aside. Carefully drill two (2)
pilot holes using the 5/64” drill bit and drill, making
sure not to drill too deep. Place the VSM G3 over
the two pilot holes. Insert the two (2) provided
screws and tighten.
STEP 3. Re-assemble the dash in reverse order. This
completes the installation of your VSM G3.
Note: See the Assembly Instructions for G3
Components for additional information.
1
2
3
Pro.Fit International, Inc.® may not be held liable for any damage to a vehicle before, during or after the installation or removal of this VSM
G3. Pro.Fit International may not be held liable for any personal injury resulting from accident or improper installation. Pro.Fit International,
Inc.® 1335 Eagandale Court, Eagan, MN 55121, Ph: 651.688.3588 or 800.388.0073 Fx: 651.688.9876
© Pro.Fit International, Eagan, MN 2008
Page 2 of 3
View Instruction & Updates
Online at
www.pro-fit-intl.com
When properly installed, the metal between the ball and 2 small holes is all that is exposed.
(Some exceptions apply).