Tripp Lite SmartRack SRCABLELADDER - Manual (Page 7)

7
3-5 Installation Within Row
(continued)
3-6 Ground Connection
After installing the SRCABLELADDER accessory, determine
where to place ground brackets by noting the distance between
one end of the ladder and the grounding post A at the corner of the
nearest SRCABLETRAY accessory.
Place a ground bracket B near the end of the SRCABLELADDER
accessory’s leg and use a hex-head bolt C to secure it.
Use the included hex nuts and lock washers G to connect one end
of the included ground cable H to a grounding post I at the corner
of the nearest SRCABLETRAY accessory and connect the other
end to the grounding post J of the ground bracket attached to the
SRCABLELADDER accessory. Repeat steps 1 to 3 for the other
end of the SRCABLELADDER accessory.
After inserting the clevis pins, insert a cotter pin G through the
hole at the end of each clevis pin. (The straight section of the
cotter pin goes through the hole.)
1
6
2
3
G
6
A
1
2
3
B
C
G
G
H
I
J
3 – Installation
(continued)