Thermador PROFESSIONAL PH PH54 - Manual (Page 7)

English 5
Wall Mount Installation
Figure 3 shows a typical installation of the hood with a duct
cover. Accessory 6” and/or 12” duct covers are used to fill
the space between the hood and ceiling.
The installation height shown in Figure 3 is 36"; however, it
is necessary to follow the cooking appliance
manufacturer’s installation instructions for proper hood
height. One 6" duct cover has been used in this installation.
Add or subtract duct covers as appropriate to
accommodate ceiling height and recommended hood
height. The duct cover structure is supported by the hood.
NOTICE:
The hood could incur some damage from heat if a
Professional Series Range or Cooktop is operated with
multiple burners at high settings under a hood that is
installed at minimum clearances.
1. After the hood installation height has been determined,
draw a horizontal line at a distance above the cooktop
equal to the recommended hood installation height
plus 15-1/2”. This line is the mounting location of the
wooden bracket shipped with the hood.
2. Find the centerline of the cooktop. Draw a vertical line
along this centerline up to the horizontal line drawn in
Step 1.
3. The hood is mounted to the wall using a wooden
bracket shipped with the hood. Remove the bracket
from the hood by removing two shipping screws. Mark
the center line of the bracket.
4. Locate one stud on either side of the cooktop
centerline to use for mounting the wooden bracket as
shown in Figure 4.
5. Align the top of the wood bracket along the horizontal
line drawn in Step 1. Align the centerlines of the
bracket and cooktop.
6. Drill a 3” deep 1/8" tap hole through the wooden
bracket, drywall, and into the stud.
Figure 3: Typical Hood Installation
Standard
8 ft Ceiling
(96")
6"
Duct Cover
Hood Height (36")
Standard
36" high
Range
18"
24"
NOTE:
Follow cooking appliance
manufacturer’s recommendations.
Figure 4: Mounting the Wooden Bracket
Height
Above
Cooktop
Cooktop
Centerline
Drywall
Wall
Studs
Screws
(2 ea
#14 x 3")
To Cooktop
Surface
Recommended
Hood Height
+15-1/2"
Wooden Bracket