TERK Technologies TV38 HDTV - Manual (Page 3)

Antenna Assembly
TV36
4
Antenna Assembly
(continued)
1. Unfold the elements on the two reflector booms until they lock
into place. Make sure that they are straight and perpendicular to
the boom.
2. Attach the two reflector booms using the attached nut and bolt so
that they are perpendicular to the smaller boom. (See figure 1.)
3. Unfold the reflector booms until they lock into place.
(See figure 2.)
4. Unfold all the other elements on the antenna until they lock
into place ensuring that they are flat and parallel to each other.
(See figure 3.)
TV38
Fig. 3
Fig. 1
Fig. 2
Front Boom
Mast
Large Boom
Rear Boom
Boom Brace
Reflector Booms
3
T0437-TV38 Revise-OM.qxp 11/11/03 04:34 AM Page 3