Transition Networks SSDTF1029-106 - Manual

Installation . . . . . . . . . . . . . . . . . . . . .3
Operation . . . . . . . . . . . . . . . . . . . . . .9
Cable Specifications . . . . . . . . . . . . .10
Technical Specifications . . . . . . . . . .12
Troubleshooting . . . . . . . . . . . . . . . .13
Compliance Information . . . . . . . . .16 * Typical maximum cable distance. (Actual
distance is dependent upon the physical
characteristics of the network.)
Note: The SSDTF10xx-10x requires a CSU
between the device and the Public Telephone
Network.
SSDTF1027-105 RJ-45
1.5 km (5,000 feet) * ST, 1300 nm multimode
5 km (3.1 miles)*
Part Number Port One - Copper Port Two - Duplex Fiber-Optic
SSDTF1011-105 RJ-45
1.5 km (5,000 feet) * ST, 850 nm multimode
2 km (1.2 miles)*
SSDTF1012-105 RJ-45
1.5 km (5,000 feet) * ST, 1310 nm single mode
8 km (4.8 miles)*
SSDTF1013-105 RJ-45
1.5 km (5,000 feet) * SC, 850 nm multimode
2 km (1.2 miles)*
SSDTF1014-105 RJ-45
1.5 km (5,000 feet) * SC, 1310 nm single mode
20 km (12.4 miles)*
SSDTF1015-105 RJ-45
1.5 km (5,000 feet) * SC, 1310 nm single mode
40 km (24.8 miles)*
SSDTF1016-105 RJ-45
1.5 km (5,000 feet) * SC, 1310 nm single mode
60 km (37.3 miles)*
SSDTF1017-105 RJ-45
1.5 km (5,000 feet) * SC, 1550 nm single mode
80 km (49.7 miles)*
SSDTF1018-105 RJ-45
1.5 km (5,000 feet) * MT-RJ, 1300 nm multimode
2 km (1.2 miles)*
SSDTF1022-105 RJ-45
1.5 km (5,000 feet) * ST, 1310 nm single mode
15 km (9.3 miles)*
SSDTF1025-105 RJ-45
1.5 km (5,000 feet) * MT-RJ, 1310 nm single mode
20 km (12.4 miles)*
User’s Guide
SSDTF10xx-10x
Stand-Alone Devices
•
T1 / E1 with Remote Management
• Copper to Fiber
Transition Networks SSDTF10xx-10x series
Devices encode and decode T1 or E1 twisted-pair
copper signals over fiber optic cable to extend the
distance and transmission reliability of high-speed
T1 or E1 data traffic. The device is framing independent (as ESF vs. D4) and supports all
common line codes (e.g., AMI, B8ZS, HDB3).
The SSDTF10xx-10x is designed to be installed in pairs. For example, install one
SSDTF1011-105 as the “local ” Device and another SSDTF1011-105 as the “remote ”
Device.