Toshiba Tosvert RS485 - Manual (Page 47)

E6581315
46
„ Communication command2
(Communication Number : FA20, FA22)
This command is enabled only when the communication command is enabled. Set Bit 15 of Com-
munication Command 1 (communication Number: FA00, FA04) to “1” (enable). When enabling the
communication command by Communication Command 1, commands by communication can be
given
the priority irrespective of the setting of the command mode selection parameter ().
However, if “48 (49): Forced switching from communication to local,” “56 (57): Forced continuous
operation,” or “58 (59): Specified speed operationj” is set by input terminal function selection
( to ), the enabled command and frequency will be given the priority.
Once enabled, this setting will be enabled till disable is set (0 setting), power is turned off or is reset,
or factory default setting () is selected.
Table 2 Data construction of communication command 2 (FA20, FA22)
Bit Function 0 1 Remarks
0 Control switching Speed control Torque control
1
electric power quantity
reset
ＯＦＦ Reset
Electric power quantity
(FE76, FE77) reset
2 (Reserved)
3 Braking request (BC) Normal Forcibly braked
4 Preliminary excitation Normal Enabled
5 Brake release (B) Brake applied Brake released
6 Braking answer (BA) Brake applied Brake released
7
Maximum deceleration
forced stop
Normal Enabled
8
Acceleration/deceleration
pattern selection 1
9
Acceleration/deceleration
pattern selection 2
00: Acceleration/deceleration 1
01: Acceleration/deceleration 2
10: Acceleration/deceleration 3
11: Acceleration/deceleration 4
Select Acceleration/ de-
celeration 1 - 4 by combi-
nation of two bits
AD1: , 
AD2: , 
AD3: , 
AD4: , 
10 V/Fswitching 1
11 V/Fswitching 2
00: V/F 1
01: V/F 2
10: V/F 3
11: V/F 4
Select V/F 1 - 4 by combi-
nation of two bits
12 Torque limit switching 1
13 Torque limit switching 2
00: Torque limit 1
01: Torque limit 2
10: Torque limit 3
11: Torque limit 4
Select torque limit 1 - 4 by
combination of two bits
14 Speed gain 1/2 Gain 1 Gain 2
Gain 1: , 
Gain 2: , 
15 (Reserved)
Note: The acceleration/deceleration change command ORs with Bit 6 of Communication number
FA00 and FA04.
Set Bit 6 of FA00 and FA04 to “0” and use FA20 and FA22 when changing acceleration/deceleration
in four types. Acceleration/deceleration 4 will be set when both Bit 8 of Communication number
FA20 and FA22 (or Bit 6 of Communication number FA00 and FA04) and Bit 9 of Communication
number FA20 and FA22 are set.