Technicolor - Thomson EFC030 - Manual (Page 5)

5
Getting started
EN
O O Using the remote control for other equipment
The remote control supplied with your television may vary depending on the model you have chosen. Some remote
controls can be used for other equipment, such as video recorders or DVD players.This page provides information
concerning the remote control’s use with some of these other types of equipment.
VCR DVD
VCR Press the VCR button
DVD Press the DVD button
B B
On/Standby On/Standby
MENU To display the main menu To display the main menu
Vertical scrolling in menus Vertical scrolling in menus
Horizontal scrolling in menus Horizontal scrolling in menus
OK To confirm an action To confirm an action
EXIT To close a menu To close a menu
0-9 To directly access channels or enter To enter numeric values or select options
numeric values in menus
PR+/PR- To change channels
AV To select av input
REV Rewind Rewind
PLAY Play Play
FWD Fast forward Fast forward
STOP Stop Stop
PAUSE Pause picture Pause picture
REC Record
Programming the remote control
Automatic code search
This method can be used to automatically find the most appropriate code for your appliance.
1. Switch on the appliance you wish to use the remote control with.
2. Press the relevant button for this appliance on the remote control, and while holding this button down, press the B
standby button until the remote control light comes on. Release the two buttons.
3. Point the remote control at the appliance and press PLAY .Wait until the light stops flashing. If the appliance has not gone
into standby mode after five seconds, press the PLAY button again to continue the search for the next set of codes.
Repeat this operation until the appliance goes into standby mode.There are 20 sets of codes.
4. When the appliance goes into standby mode, press the standby B button on the front to switch it on again.Then press
the
REV button to put it back in standby mode, and if necessary, keep pressing until the appliance goes into standby.
5. Press the STOP button and hold it down until the remote control light goes off.
Note: you can cancel the programming operation at any time by pressing the EXIT button.
Manual programming
This method involves carrying out a manual search for the codes to be used for controlling your other appliances.
1. Switch on the appliance you wish to use the remote control with.
2. Press the relevant button for this appliance on the remote control, and while holding this button down, enter one of the
four-digit codes relevant to your make of appliance (there is a list of codes at the end of this manual). If the remote
control light flashes you have entered the wrong code or it is not possible to program the remote control.
3. Point the remote control at the appliance and press the relevant button ( VCR or DVD ). Press the B standby button. If
the appliance does not go into standby mode, try another code.
Depending on the year of manufacture and the type of appliance, some functions may not be available.
Certain codes may cover more functions than others.Test the functions you can control and, if appropriate, try other codes.
Note here the code(s) which work best.
When you change the remote control’s batteries, remember to reprogram it.
VCR
DVD/LD
06-EFC030-EN.qxd 15/06/05 13:40 Page 5