Therma-Stor Products Group Santa-Fe Rx Free-Standing Dehumidification - Manual (Page 9)

This kit attaches to the back of the Santa Fe Rx. The back is the
side where the air comes out of the lower section.
1. Remove the protective plastic from the frame top & sides.
Assemble the frame top (Item 1) & bottom (Item 2) to the frame sides
(Items 3) with (8) screws (Item 6). The frame bottom has 3⁄4" thick
by 1" wide foam on one outer edge. The frame top has 1⁄2" thick by
1⁄2" wide foam on the equivalent edge.
2. Push the plastic nuts into the (6) square holes on the unit back.
If they are difficult to push in, gently tap them in with a hammer or
rubber mallet.
NOTE: The service panel on the back of the unit
(26 1⁄4" high x 18 1⁄ 2" wide, held with 6 screws)
must remain in place when using this filter frame
assembly. DO NOT REMOVE.
3. Place a rug or cardboard down and lay the Santa Fe Rx on its
front. Screw the frame to the Santa Fe Rx back with (6) screws (Item
6) into the plastic nuts starting with the middle screws. Stand unit
upright.
4. Remove the (4) screws that attach the frame top to the frame
sides.
5. Attach the “C” shaped filter guides (Items 4) to the inside of the
frame sides with machine screws and lock nuts (Items 5 & 7). Place
the nuts to the inside.
6. Slide the air filter(s) into the filter guides from the top.
7. Reattach the top.
8. Reposition the Santa Fe Rx with the back of the unit at least 1.5"
from a wall with the optional filter frame. Without the filter frame, at
least 3" is required.
Filter Test
The optional 95% efficiency and HEPA filters have long lives
when prefitered by the standard pleated inlet filter; they can
last many years in certain conditions. How long they last can,
however, vary widely depending upon the following: Unit run time,
air contamination level, and standard inlet filter cleanliness. Due
to the optional filters’ expense, it can be costly to change them
prematurely. The following test helps determine when they should be
changed.
Air exiting the bottom rear of the unit enters the filter frame, then
passes through the optional filter and into the room. If the filter is
dirty, air pressure builds up before the filter. To check this pressure,
remove the plastic plug from the filter frame top; you will feel air
coming out of the hole with the unit running. Place the ping pong ball
that came with the filter frame on the hole and let go (any marked,
regulation sized ping pong ball will work). If the ball does not move
or only bounces slightly and does not spin continuously, the filter is
clean enough for continued use. If the ball floats above the hole and
starts to spin and perhaps wobble within 30 seconds, the filter needs
to be changed.
Parts List
ITEM NO. PART NO. QUANTITY DESCRIPTION
1. 4023947 1 Frame Top
2. 4023948 1 Frame Bottom
3. 4023946 2 Frame Side
4. 4023606 2 Filter Guide (“C” shaped)
5. 1096181 4 Machine Screw, #8-32 x
1⁄2" long
6. 1027265 16 Thread Forming Screw,
#8-18 x 1⁄ 2" long (1 spare)
7. 1280378 4 Lock Nut, #8-32
8. 4024105 1 Ping Pong Ball (used for
Filter Test: Save)
SANTA FE Rx FILTER FRAME ASSEMBLY
9 Santa Fe Rx Installer’s & Owner’s Manual