Least cost routing (lcr), Line buttons, Co line buttons – Toshiba Strata CTX100 User Manual

Page 71: Pooled co line button, Least cost routing (lcr) line buttons, Co line buttons pooled co line button

Advertising
background image

Features

Least Cost Routing (LCR)

Strata CTX General Description 11/02

57

ISDN service comes in two forms:

Primary Rate Interface (PRI) supports simultaneous voice or data connections (eight, 16 or
23). PRI is similar to digital T1 service and uses two pairs of wires from your phone company.
The RPTU PCB supports PRI on the Strata CTX.

Basic Rate Interface (BRI) supports up to two simultaneous connections using a single pair of
wires. The Strata CTX BRI cards support both station side and trunk side connections. Strata
CTX systems also support BRI interface from the public network as a CO line service. There
are two types of ISDN BRI interfaces: S/T type (via RBSU/RBSS) and the
U-type (via RBUU/RBUS).

Least Cost Routing (LCR)

Least Cost Routing chooses the most appropriate route over which to connect an outgoing call
based on the following:

Dialed Digits

Time of Day

Type of Day (Business, Weekend, Holiday)

LCR group of the caller

The combination of routing tables, indices, route definitions and time-of-day qualifiers can
produce up to 75 million combinations. Routing changes automatically for each type of day,
according to the time of day. This schedule is independent of the Day/Night mode schedule which
applies to ringing and CO assignments.

Line Buttons

Telephone buttons that are used for making and receiving outside calls are referred to as

/LQH

(or

&2 /LQH

) buttons. (For information on various [DN] buttons, refer to

“Directory Numbers” on

page 51

.) The Strata CTX supports the following types of line buttons:

CO Line Buttons

Smaller systems have traditionally provided the direct appearance of the CO lines on the
telephones where maximum visibility of the line status, flexible ringing assignments, and informal
call transfers associated with key telephone systems may be implemented.

Pooled CO Line Button

Pooled Line Group buttons enable a group of CO lines to “appear” under one button. Pooled and
single appearing line buttons are designed for use with loop and ground start lines, not Tie, DID,
DNIS or ANI lines.

Advertising
This manual is related to the following products: