Tannoy CYBER-SHOT C902 - Manual (Page 32)

30 Calling
To record a voice command using
voice dialling
1 From standby select Menu > Settings
> the General tab > Voice control >
Voice dialling > Activate .
2 Select Yes > New voice command and
select a contact. If the contact has more
than one number, select the number
to add the voice command to.
3 Record a voice command such as
“John mobile”.
4 Follow the instructions that appear.
Wait for the tone and say the command
to record. The voice command is played
back to you.
5 If the recording sounds OK, select Yes .
If not, select No and repeat steps
3 and 4.
Voice dialling
You can hear your recorded contact
name when you receive a call from
that contact.
To voice dial
1 From standby press and hold down
a volume key.
2 Wait for the tone and say a recorded
name, for example “John mobile”. The
name is played back to you and the
call is connected.
Voice answering
When you use a handsfree, you can
answer or reject incoming calls with
your voice.
To activate voice answering and
record voice answer commands
1 From standby select Menu > Settings
> the General tab > Voice control >
Voice answer > Activate .
2 Follow the instructions that appear and
select
Cont. Wait for the tone and say
“Answer”, or another word.
3 Select Yes to accept or No for a new
recording.
4 Follow the instructions that appear and
select
Cont. Wait for the tone and say
“Busy”, or another word.
5 Select Yes to accept or No for a new
recording.
6 Follow the instructions that appear
and select Cont.
7 Select where your voice answering
is to be activated.
To answer a call using voice
commands
• Say “Answer”.
To reject a call using voice
commands
• Say “Busy”.
Voice commands are saved in the phone
memory only. They cannot be used in
another phone.
This is the Internet version of the User's guide. © Print only for private use.