The Singing Machine SMB-637 - Manual (Page 7)

6
PROGRAMMED PLAY
Ensure CD is in the stop mode.
Press the PROG/MEM button, "PROG" and "00" will show in the display and flash.
Using the SKIP buttons >>I or I<< select the first track to be memorized.
Press the PROG/MEM button. This track is now placed in the memory.
Repeat the above process up to a maximum of 20 tracks. If more than 20 tracks are
entered, "PROG" and " - - " will flash in the display to indicate the program is full and no
further tracks should be entered.
To play the programmed selection, press the PLAY/PAUSE button.
To cancel Programmed play and resume normal playback, press the STOP button at
program mode.
The selected programmed track is deleted from the program when either the CD lid is
opened or another function is selected Tape, Radio etc.
This function can also be used when making a recording from CD.
To recall the programmed selection (providing the CD door has not been opened or
another function selected) press PROG/MEM button twice. 1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
Up to 20 tracks can be programmed for playback in any desired order.
Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to contact
with the shiny, unprinted side of the disc.
Do not attach adhesive tape, stickers etc., to the disc label.
Clean the disc periodically with soft, lint-free, dry cloth. Never use detergents or adhesive
cleaners to clean the disc. If necessary, use a CD cleaning kit.
If disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
When cleaning the disc, wipe in straight lines from the centre of the disc to the edge of the disc.
Never wipe in circular motions.
To remove a disc from its storage case, press down on the centre of the case and lift the disc
out, holding it carefully by the edges.
Fingerprints and dust should be carefully wiped off the disc's recorded surface with a soft cloth.
Unlike conventional records. compact disc has no groove to collect dust and microscopic
debris, so gently wiping with a soft cloth should remove most particles.
CARE AND MAINTENANCE (CD PLAYER)
SPECIFICATION
POWER SUPPLY
AC:
Batteries:
RADIO FREQUENCY COVERAGE
FM:
AM:
GENERAL
CD PLAYER
Speaker:
Pick Up:
Encoding:
AC120V~60Hz
DC 9V
6 x R14 or equivalent
88 - 108MHz
530 - 1700KHz
8 Ohms
3-Beam, Semiconductor Laser
1 Bit DA Convertor
8 Time Oversampling
RECORDING SYSTEM
Recording System:
Erasing System: DC Bias
Magnet Erase