T+A Elektroakustik K 6 - Manual (Page 16)

Operation 16
Renaming a Program
Operation:
With Tuner selected . . .
   
press
briefly
Call up Tuner Menu *)
e.g.
MODE NORM MODE NORM MODE NORM MODE NORM
    Call up Program Menu *) PROGRAM PROGRAM PROGRAM PROGRAM
    Confirm selection
e.g.
P01 105-60 P01 105-60 P01 105-60 P01 105-60
   
Press repeatedly until the
display shown here ap-
pears on the integral
screen
e.g.
RENAME P01 RENAME P01 RENAME P01 RENAME P01
    /    
Select the Program Num-
ber whose name is to be
edited
   
to
   
Optional: enter Program
Number directly
e.g.
RENAME P05 RENAME P05 RENAME P05 RENAME P05
    Activate name input
e.g.
WDR 4 WDR 4 WDR 4 WDR 4
    /     Change input position
e.g.
_ _ _ _ WDR 4 WDR 4 WDR 4 WDR 4
   
   
Change the letter at the
input position e.g.
M WDR 4 M WDR 4 M WDR 4 M WDR 4
Repeat the last two steps until the desired name is dis-
played on the screen, then
   
Store name and close
Tuner Menu e.g.
MEINNAME MEINNAME MEINNAME MEINNAME
or
   
Leave Tuner Menu with-
out storing the name
*) The Tuner Menu and the Program Menu are also
displayed on the screen of a TV set connected to the
system (see illustrations on previous page).
Explanation:
Not all radio transmitters broadcast the station name, and
in such cases the integral screen displays the tuning indi-
cator and the reception frequency instead of the station
name. Other transmitters broadcast the station name as a
moving script, which is at variance with the RDS norm.
If you wish to display a 'program name' on the integral
screen in such cases, you can use the K6's Rename
function. This process enables you to assign any name to
each Program Number.
First call up the Rename function, then use the     /    
buttons or the numeric buttons to enter the Program Num-
ber whose name is to be entered or changed.
Press the     button, and you are ready to edit the
name.
You will see a flashing pointer, or cursor, on the integral
screen and the screen of a TV set connected to the sys-
tem. This cursor indicates the input position, and you can
move it using the
    /     buttons.
Use the     and     buttons to change the letters at the
input position.
You can now enter the name of your choice, between one
and eight letters in length. The new name is stored when
you press the
    button.
Note
A name you choose yourself takes priority over the RDS
station name which the radio transmitter broadcasts, i.e. it
not over-written by the RDS name. If you wish to erase
your selected name you must clear the Program Number
and store the program again under the same Program
Number.