TechniSat DigiBox VIACCESS User Manual
Page 16
The following selections can be made in this sub-menu:
5.4.1 Switching DiSEqC on or off
DiSEqC (
D
igital Satellite
Eq
uipment
C
ontrol) is a digital signal that can control the functions
of DiSEqC-compatible components via the antenna connection.
If your external installation features DiSEqC components, you should enable the DiSEqC
control function:
>
When this entry is highlighted, use the
OK
key to switch the
DiSEqC
function
on
or
off
.
5.4.2 Adjusting the Switching Matrix and LNB Properties
The menu reflects the four switching criteria of the DiSEqC control.
Your receiver is pre-programmed to receive ASTRA broadcasts on switch setting A/A, and
EUTELSAT signals on setting B/A of a Multiswitch. Should the switching matrix of your exter-
nal receiving unit be set up differently, or should you wish to receive satellite signals other
than those mentioned, you can adjust the receiver settings as follows:
>
Use the
up/down arrow
keys to select the DiSEqC switch position (1-4) that you
wish to use for allocation to a satellite (e.g.
A/B 3 No Satellite
), and highlight the
appropriate entry.
>
Press the
OK
key to confirm.
A list of several satellites will be displayed, from which you can make your selection.
>
Use the
up/down arrow
keys to select the appropriate satellite.
Pressing the
up/down arrow
keys will move the marker by one line at a time, up or
down, while the
left/right arrow
keys will take you to the previous or following
pages respectively.
Should the satellite you are looking for not be included in the list, please select one of
the spare settings, which are marked
User 1
to
User 15
.
>
Confirm by pressing the
OK
key.
The highlighted entry will now be inserted in the
Menu >Settings>LNB
at the pre-
viously selected position
In this way, you can continue to customise the
Menu>Settings>LNB
until all the informa-
tion in this menu correspond to those of your receiving unit. For those switiching criteria you
do not require you should select the setting
No Satellite
.
5.4.3 Additional Settings
Now that the switching matrix of your DVB receiver has been adjusted to conform to your
external reception equipment, you should also check on the other settings for your receiving
equipment, and adjust the settings where necessary.
>
Use the
left/right arrow
keys to mark the entry
Check LNB
.
>
Using the
up/down arrow
keys to move around the field
Check LNB
, select the
satellite position (1-4) that you wish to adjust resp. check on; mark the entry
Pro-
ceed
in blue.
16
bed_anl_DigiBox_Viaccess_englisch.qxd 13.08.01 11:42 Seite 16