Teac DVW-D110H - Manual (Page 19)

Operation Mode Functions
TEAC 1x10 DVD Duplicator User’s Manual 11
Chapter 3. DVD Duplicator Functions
The DVD Duplicator features three (3) modes of operation:
❑
Operation mode
❑
Setup mode
❑
Advanced mode
Operation Mode Functions
Operation mode includes seven (7) functions. Each function is explained below.
Test
The Test function simulates writing to the target disc. The discs will remain blank
after the test is complete. This function is recommended if you are using
unsupported media. This function enables the target drive to adjust the laser to the
proper intensity. The source drive, which is determined by the setting on the
Duplicator controller, can be either the DVD-ROM drive or the hard disk drive.
Copy
The Copy function enables you to copy data from the source DVD or a partition
on the internal hard disk drive. For more information, refer to “Basic Operation”
on page 8.
Compare
The Compare function compares data on the source and target discs after the copy
process is complete.
Copy and Compare
The Compare function follows immediately as soon as the Copy function is
completed.
Verify
The Verify function verifies that the target disc was written completely and with
no errors.