TP-Link P912A - Manual (Page 7)

Type
Output Power
Power Band Width
Frequency Response
Total Harmonic Distortion
Inputs
Input Sensitivity/Impedance
Outputs
(D) - Direct
(T) - Transformer
Output Regulation (1 kHz)
Signal to Noise Ratio
Controls
Indicator
Protection
Connectors
Power Consumption
Temperature Range
Dimensions in mm (inches)
(high) x (wide) x (deep)
Weight (without input modules)
Color
Other Features
P-906A P-912A
Power amplifier
60 watts RMS 120 watts RMS
+1dB
— 3db
0.01% at 1 kHz, rated output
One Input Port : Port accepts any input module except T-01, which cannot be used.
One Direct Input
Note : Use of direct input prohibits use of modular input port.
Input Port : 100 mV or 1,000 mV (Switchable)/10k ohms
Direct Input : 100 mV or 1,000 mV (Switchable)/10k ohms
Main (T) : 8 ohms, 25 & 70 volts, balanced
Main (D): 4 ohms, unbalanced
(D) Less than 0.5 dB, no load to full load (T) Less than 1.0 dB, no load to full load
Input level switch in 0 dBv (1,000 mV) position : 108 dB
Input level switch in -20 dBv (100 mV) position : 90 dB
1 Input gain control
1 Input level switch
1 Low-cut switch (60 Hz, 6 dB/octave)
1 Illuminated VU meter
Self-protection, with 2 AC fuses (1 inside) and 1 output fuse
Inputs . . . . . . . . . . . . . . . . .Card-edge connector and screw-terminal strip
Outputs . . . . . . . . . . . . . . . .Screw-terminal strip
AC outlet . . . . . . . . . . . . . . .3-pin grounding type
AC power cord/plug . . . . . . . . .SJT, 3-prong type
AC 1 20 volts, 60 Hz, 100 watts AC 120 volts, 60 Hz, 180 watts
-10°C to+60°C (12°F to 140°F)
145 (5.71") x 420 (16.54") x 315 (12.40")
Rack-mounting space size "3U" (5.21")
10.4 kg (22.9 Ibs.) 14.2kg (31.2 Ibs.)
Silver
Output disconnected for approx. 5 sec after switching power on.
Specifications are subject to change without notice.
Specifications
( D ) 20—20,000 Hz 0.5% THD
1 Power ON/OFF switch
(T) 50 —20,000 Hz 0.5% THD
(D) 20— 20,000 Hz, ±1 dB
(T) 20— 15,000 Hz, ±1 dB
(T) 20— 20,000 Hz,
(Band Pass 20 — 20,000 Hz)
— 6 —