Toshiba 36ZP18Q - Manual (Page 20)

Selecting the character set and viewing mode and general information
20
TELETEXT
Teletext – setting up
This TV has a multi-page teletext memory, which takes a few moments to load and it offers two ways of
viewing text – AUTO and LIST which are explained on the next page.
Teletext continued over the page…
The 6 / 7 button:
Pressing the 6 / 7 button once will bring up the teletext
screen. Press again to superimpose the teletext over a
normal broadcast picture. Press again to return to normal
TV mode. You need to return to normal viewing if you
wish to change channels.
When you first press the 6 / 7 button to access the text
service, the first page you see will be the initial page.
In AUTO mode this displays the main subjects available and
their relevant page numbers.
In LIST mode you will see whichever page number is
currently stored on the RED button.
To access any teletext page, enter the 3 digit page number,
using the numbered buttons on the remote control,
e.g. 430, or to advance to the next page, press the
P
f ( P ) button, to go back to the previous page press the
P e ( Q ) button.
Sub-pages
Once in this chosen page, if there are sub-pages they will
automatically load into memory without changing the
one you are reading. Arrows will appear alongside the
page number, indicating sub-pages which have loaded to
the left or right of the one on the screen. If there are many
sub-pages it will take a long time for them all to load and
this will depend on the speed with which the broadcaster
transmits them.
To access the sub-pages in
memory press the
X X ( B B )
button, then use the
S Sand R R buttons to view
them.
Whilst in sub-pages mode an indicator will show in the
bottom left of the screen. After a short time of inactivity the
indicator will disappear. To access the sub-pages again press
the
X ( B ) button.
These sub-pages will remain available to view until you
choose another page or, in normal TV mode, you change
channel.
About teletext
Selecting characters and modes
2
3
4
5
TELETEXT
▼
▼
▼
To select the Mode , with the Q button highlight
Mode .
With the S or R button choose AUTO or LIST.
Press EXIT to finish.
▼
▼
Back
Character CHARACTER-1
Mode AUTO
From the SET UP menu, use the P or Q button
to highlight Teletext and then the R button to
select.
With Character highlighted, use the R button to
select your required character set.
Before using teletext you can choose the correct alphabet
( Character ) and whether to view in LIST or AUTO mode,
(explained on the next page).
1
To alter the volume
you will need to cancel
sub-pages mode by
pressing the
X ( B )
button first.
☛
CHARACTER-1 for Western European countries and Turkey
CHARACTER-2 for Eastern European countries