Technicolor - Thomson RR420CD - Manual (Page 9)

EN
Operating the Alarm
Setting the WAKE Time
Your digital clock operates on a 24 hour
standard mechanism.
1. Press the SET button until ALARM 1 /
ALARM 2 icon is blinking.
2. Press REV
or FWD to set the wake
time. The time decrements or increments
will follow by a faster rate when you press
and hold either REV
or FWD .
3. After the ALARM time is set, press SET
repeatedly until no icon is blinking.
Waking by Selected Source
You may be woken up by ALARM , RA-
DIO or CD .
1. Select an MW or FM station.
2. Set wake time (see above directions).
3. Press ALARM 2 or ALARM 1 to select
waking up by ALARM , RADIO or CD
. Corresponding indicator will be up
next to the selected setting.
4. Adjust the volume by turning VOLUME.
You can select your CD wake track by the
following procedures.
1. Press WAKE UP CD TRACK.
2. While pressing, press REV
or FWD
to select your desired CD wake up track.
7
Tip Tip Tip Tip Tip:
The unit equips with GRAD-U-
GRAD-U- GRAD-U- GRAD-U- GRAD-U-
WAKE WAKE WAKE WAKE WAKE feature, the alarm tone
volume will increase gradually
to its maximum in about 30 to 45
seconds.
Tip Tip Tip Tip Tip:
If you set the SLEEP function
with low volume level before
going to bed, we advise using
ALARM mode to wake you up since its
volume will automatically increase.
Note Note Note Note Note:
When you turn off the alarm
by pressing OFF
OFF OFF OFF OFF, the alarm
will turn on at the same time
tomorrow.