Toshiba RTM20 - Manual (Page 10)

T O S H I B A
Section trio temperature set switch
Section trip temperature set switches 8 to 10 can be
set from C to C in increments. Set using
either the or switches and add the
temperature indicated on the right-hand switch. Then
the required value is set.
RTD use or not use selection switch
On . . . . . . . to use
Off . . . . . . not to use
Temperature set mode selection switch:
On . . . . . . . Ch. 1 to 6 . . . . . Section (A)
Ch. 7 to 8 . . . . . Section setting
Off . . . . . Ch. 1 to 3 . . . . . Section setting
Ch. 4 and 5 . . . . Section setting
6 to . . . . . Section setting
Write the monitored part or area name on each channel.
Temperature indicator set switch. This switch is used to
select the RTD channel. Depressing the switch incre-
mentally changes the channel.
Manual reset switch. This feature is when the
reset mode switch is set at "Manual". Depress the switch
and reset the temperature indicator, alarm, trip
and peak hold values.
RTD selection switch
Select only one of either Pt Ni Ni
or Cu Then set. If you try to choose more than
one metal, the trip indicator will
Reset selection switch
. . . . . Manual reset
The trip/alarm indicator, and alarm/trip
values are kept until the manual reset switch is on.
A . . . . . Auto reset
The and the output are auto-
matically reset when abnormal conditions are
removed.