Technicolor - Thomson PT-AE2000E - Manual (Page 19)

E
NGLISH - 19
Basic O
p
eration
Switching the projector on/off
J Connecting
1. Make sure the shape of
the mains plug and the
AC IN connector on the
back of the projector
match, then push the plug all the way in.
2. Connect the mains lead to a mains socket.
J Disconnecting
1. Make sure the MAIN POWER is switched off and
unplug the mains lead from the mains socket.
2. Hold the plug and unplug the mains lead from the
AC IN connector on the side of the projector.
Mains lead
NOTE:
• Do not use other than the provided mains lead.
• Ensure all the input devices are connected and turned off before connecting the mains lead.
• Do not force the connector as this may damage the projector and/or the mains lead.
• Dirt or dust build-up around plugs may cause fire or electrical hazards.
• Switch off the power to the projector when not in use.
POWER indicator
Indicator status Status
No illumination or flashing The MAIN POWER button is switched off.
Red Lit The MAIN POWER button is switched on and the projector is in standby.
Green
Flashing The POWER button is switched on and the projector is getting ready to project.
Lit The projector is ready to project.
Orange
Lit The POWER button is switched off and the projector is cooling the lamp.
Flashing
The POWER button is switched on again when cooling the lamp and recovering to
projection mode. Recovery may take a while.
NOTE:
• While the projector is cooling the lamp, do not switch the MAIN POWER button off or unplug the mains lead.
• The electric consumption in standby mode is 0.08 W.
POWER indicator