Telenetics 56 - Manual (Page 39)

AT Commands
Page 31
The following syntax is used for parameters that accept a single value:
+<name>=[<value>]
The following syntax is used for parameters that accept more than one value:
+<name>=[<compound_value>]
For each implemented parameter, if all mandatory values are specified, and all values are
valid according to the definition of the parameter, the specified values are stored. If
<name> is not recognized, one or more mandatory values are omitted, or one or more
values are of the wrong type or outside the permitted range, the modem issues the
ERROR result code and terminates processing of the command line. An ERROR is also
generated if too many values are specified. In case of an error, all previous values of the
parameter are unaffected.
Parameter Read Command Syntax
The DTE may determine the current value or values stored in a parameter by using the
following syntax:
+<name>?
The modem responds by sending the current values stored for the parameter to the DTE
in an information text response. The format of this response is described in the definition
of the parameter. Generally, the values are sent in the same form in which they would be
issued by the DTE in a parameter setting command; if multiple values are supported, they
will generally be separated by commas, as in a parameter setting command.
Parameter Test Command Syntax
The DTE may test if a parameter is implemented in the modem, and determine the
supported values, by using the syntax:
+<name>=?
If the modem does not recognize the indicated name, it returns an ERROR result code
and terminates processing of the command line. If the modem does recognize the
parameter name, it returns an information text response to the DTE, followed by an OK
result code. The information text response indicates the values supported by the modem
for each such subparameter, and possibly additional information. The format of this
information text is defined for each parameter.