TrekStor i.Beat joy 2.0 - Manual (Page 25)

4.2 FAQ
I pressed
’
■q’ , but nothing appears on the LCD.
❼ There is no battery in the player or the battery is dead. Replace
the battery.
❼ The key lock function is on. Slide back the ’Hold’ hold button to
switch off the key lock function.
My computer does not recognize my TrekStor i.Beat joy 2.0 .
❼ You are using Windows 98 and have not installed the driver. Install
the driver as described in section 3.2.
❼ The firmware has been damaged. To solve this problem, follow
these steps:
– Remove the battery.
– Connect your TrekStor i.Beat joy 2.0 to your computer and
hold down the
’
■q’ button for approximately 3 seconds.
– Your TrekStor i.Beat joy 2.0 should appear in ’My Computer’
as a new drive. Update the firmware as described in sec-
tion 4.1.
There is less memory available than I though. Several factors can affect
the exact number of bytes available.
TrekStor i.Beat joy 2.0 21