Tascam RS-232C HD-R1 - Manual (Page 9)

9 TEAC Corporation
4.2 Setting commands
Most of the HD-R1’s settings can be configured remotely. Their parameter IDs and acceptable values are defined in
the following tables. With some exceptions, all parameters may both be set and queried with a command. Although
they are not case sensitive, blank spaces within parameter IDs and setting values must be exactly as shown.
The format for setting commands is the same as for others as shown in the example below.
Parameter ID Command Setting value End Marker
Character
string Auto Cue (example) =: set value
?: query
<Value>: as necessary LF (or CR+LF)
The following can be set and queried at any time.
Parameter ID Valid values
Num Of Folders Total number of folders (query only)
Num Of Playlists Total number of playlists (query only)
Repeat Off
On
Auto Ready Off
On
Auto Cue Off
-72 dBFS
-66 dBFS
-60 dBFS
-54 dBFS
-48 dBFS
-42 dBFS
-36 dBFS
-30 dBFS
-24 dBFS
Channels Mono Left
Mono Right
Mono Summed
Stereo
WAV Sample Width 16 Bits
24 Bits