Tascam DR-07MKLL - Manual (Page 2)

06/28/11
Page 2 of 2
Guide To Using
TASCAM Handheld Recorders
For DSLR Filmmaking
7733 Telegraph Rd • Montebello, CA • 90640 • 323.726.0303 • www.tascam.com
© 2011 TASCAM, a division of TEAC America. All trademarks are the property of their respective holders.
All rights reserved. Design and specifications subject to change without notice.
Connecting to your Camera
Advantages of Audio Recorders
1. Attach the recorder to your camera using a hot shoe
mount (sold separately)
2. Connect an 1/8” cable from the line/headphone output of
the recorder to the MIC IN of your camera (also sold sepa-
rately, use an attenuator cable if available)
3. Set your camera to use the line/mic input, if necessary
4. To automatically synchronize your video clips with the DR-
series recordings, use software like Adobe Premiere Pro
CS5.5, Apple Final Cut Pro X or Singular Software
PluralEyes.
• You can assign someone to just record audio, so they can get
closer to the talent with a microphone for a better recording.
• TASCAM recorders are purpose-built for audio, so setting audio
levels and adjusting settings is often as easy as a single button
press or switch
• You can set the audio recording level to be manual or automatic
• TASCAM handheld recorders have a limiter during recording, so
that sudden loud sounds won’t be distorted.
• The separate line out and headphone out on the DR-100 allows
you to listen in headphones while you send a copy of the signal
to your camera to sync up later.
• A selectable low cut filter allows you to cut bass rumble or wind
noise while recording
• Dual batteries on the DR-100 allow you to swap batteries for
extended battery life – even while recording
Optional WS-DR2 Windscreen