Tricity Bendix FD 852 A - Manual (Page 17)

17
INSTALLATION
Positioning
This appliance is designed to operate in ambient
temperatures between 10¡C (50¡ F) and 32¡C
(90¡ F). It should be located in a dry atmosphere, out
of direct sunlight and away from extreme
temperature e.g. not next to a boiler or radiator, or in
a very cold room e.g. an outhouse, where the
temperatures may fall below 10¡C (50¡ F). If these
temperatures are exceeded i.e. colder or warmer,
then the appliance may not operate correctly.
You should also ensure that air can circulate freely
around the back and the top of the cabinet. There
must also be at least 100 mm (4Ó) distance between
the top of the cabinet and any overhanging kitchen
furniture (A). Ideally, the appliance should not be
positioned beneath overhanging furniture (B).
There should also be a gap of 25 mm either side of
the appliance. Do not obstruct the space
underneath. The back of the cabinet may be placed
close to the wall but must not touch it. DO NOT
install in places with restricted ventilation.
Adjust the level of the appliance by screwing out the
adjustable foot, or feet, at the bottom of the cabinet
using your fingers.
Rear spacers
In the bag with the documentation there are two
spacers which must be fitted in the two top
corners.
Slacken the screws and insert the spacer under the
screw head, then re-tighten the screw.
D200
NP002
100 mm
10 mm 10 mm
A B
Warning
IF YOU ARE DISCARDING AN OLD APPLIANCE
THAT HAS A LOCK OR CATCH ON THE DOOR,
YOU MUST ENSURE THAT IT IS MADE
UNUSABLE TO PREVENT YOUNG CHILDREN
BEING TRAPPED INSIDE.
Depending upon the position which you choose for
your appliance, you may wish to reverse the way in
which the door opens. To do this, refer to instructions
on ÒDoor reversal directionsÓ paragraph.
D594