Topcom BUTLER 2920 - Manual (Page 9)

Topcom Butler 2920 9
ENGLISH
Topcom Butler 2920
5. HANDSET OPERATION
5.1 OUTGOING CALLS
5.1.1 Making a phone call
•
Press the Line button . You will hear the dial tone.
• Enter the desired telephone number.
• Press the Line button when you want to terminate the call.
5.1.2 Call setup with dial preparation
•
Enter the desired telephone number. An incorrect number can be corrected by means of the Mute button . When
you haven’t pressed a button for 10 seconds, the number you’ve already entered will disappear and the handset
returns to standby mode.
• Press the Line button . The number will be dialled automatically.
• Press the Line button when you want to terminate the call.
5.1.3 Redialling the last number dialled
•
Press the Line key .
• The Line/Charge indicator (LED) on the base unit will blink.
• You will hear the dial tone.
• Press the Redial key . The number you last called is dialled automatically.
5.1.4 Redial one of the last 5 numbers dialled
•
Press the Redial key . The number you last called appears on the display. If you would like to dial one of the last
5 numbers dialled, press the Redial key a few times until the desired number appears on the display.
• Press the Line key .
• The number shown on the display is dialled automatically.
• After finishing your call, press the Line key to hang up.
5.2 INCOMING CALLS
• When a call comes in, the handset will start to ring. The LED on the base will blink.
• Press the Line button to answer the incoming call.
5.3 ACTIVATE/DEACTIVATE HANDS FREE FUNCTION
This function allows you to communicate without having to pick up the handset. When you are on the phone, press the
Hands free key
to activate the hands free function.
Press the same button to deactivate the hands free function.
Note : When you are calling in hands free mode and you want to change the volume, press the Volume
button.
Attention !! When you use the hands free function for a long time, the batteries will be empty more
quickly!!
5.4 PROGRAMMING MEMORY NUMBERS
You can program 10 indirect numbers (of max. 25 digits) in the phone’s memory.
•
Press and hold the Memory button until the -icon appears on the display.
• Enter the telephone number you whish to store.
• Press the Memory button again to confirm.
• Enter the memory location (0-9) where you want to store the number.
• You will hear a confirmation tone and the -icon will disappear.
Remarks :
If you wish to insert a pause, press the Redial/Pause button
on the location where you want a pause
of 3 sec.
/P
+/B% SGI