Top Innovations SF-450 - Manual (Page 7)

STEAMER OPERATION
STEP I
-
PREPARATION FOR USE
Set the unit on the floor and remove the
water container. Check the inside of the
container for sediment. Turn the container
upside down and push the valve open and
allow to close two or three times to insure
it is functioning smoothly. If the container
has been stored with water inside, it may
be necessary to remove the water and
clean the container. Follow the steps for
care and cleaning.
STEP 2
-
FILLING THE WATER CONTAINER
(PRIOR T O PLUGGING I N T H E APPLIANCE)
Remove the water container with the handle
and turn upside down. Unscrew the valve
in the center of the base and pour water
into the opening or hold under a source of
running water until the container is filled to
the desired level. Replace the valve and
return the container to the upright position.
Place the water container onto the base
and make certain it seats properly into the
cavity.
DO NOT FILL THE CONTAINER WITH HOT WATER.
DO NOT ALLOW THE CONTAINER TO BECOME DRY DURING
OPERATION AS THIS WILL SHORTEN THE LIFE OF THE STEAMER
STEP 3
-
OPERATING THE STEAMER
Insure the ON / OFF switch is in the OFF
position. Plug the steamer cord into a normal
electrical outlet or approved extension cord.
Turn the ON
/ OFF switch to the ON position.
The switch will light when electricity is
connected. Steam will be produced from
the nozzle in
a few seconds.