Thermador HGEW36FS - Manual (Page 6)

6
OPERATION
IMPORTANT: The most effective method of
removing vapors produced during cooking
is to:
❑ Switch the ventilator ON prior to
cooking or as soon as you begin
cooking.
❑ Switch the ventilator OFF
a few minutes after you have finished
cooking.
❑ Set the glass plate in cooking
position.
cooking position
Acoustic signal:
❑ When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
❑ Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
❑ Repeat the process.
Switching the fan ON
❑ Press the + button or pull out the filter
drawer.
Setting the required fan speed:
❑ Press the + button.
The fan speed is increased by one step.
❑ Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
❑ Press the 0 button.
The displayed { goes out shortly
afterwards.
Or:
❑ Keep pressing the – button until the fan
switches off.
The displayed
{ goes out shortly
afterwards.
Intensive setting:
Maximum power is obtained at the
intensive setting.
It is only required for short intervals.
❑ Keep pressing the + button until a
ç
appears in the display.
❑ If the intensive setting is not cancelled by
hand, the
fan will automatically switch back to step
} after 10 minutes.
Fan follow-on:
❑ Press the
! button or push in the filter
drawer.
The fan runs for 10 minutes at setting 1.
At the same time a dot flashes in the
display.
Then the fan switches off automatically.
Lighting:
❑ Briefly press the a button to switch the
light on and off.
❑ The light can be switched on at any
time, even though the fan is switched off.
❑ Adjusting the brightness:
Hold down the a button until the
desired brightness is obtained.
Light Reduce fan
speed Fan ON and
increase speed
Display for fan setting Fan follow-on
Fan OFF