Section 1 introduction, 1 introduction, 1 introduction -1 – Teledyne 730 Bubbler User Manual
Page 9: 1 730 module mounted on sampler -1, 730 bubbler module
1-1
730 Bubbler Module
Section 1 Introduction
1.1 Introduction
The 730 Bubbler Module is one of Teledyne Isco’s inter-
changeable modules for the Avalanche and 6700 Series Sam-
plers. The module uses a differential pressure transducer and a
flow of bubbles to measure liquid levels up to ten feet. The
bubbler is unaffected by wind, fluctuations in air or liquid tem-
peratures, turbulence, steam, foam on the surface, corrosive
chemicals, debris, oil, floating grease, or lightning.
You can install the module only on a 6712 or 6700 controller. The
bubble line can be used in nearly any location with a known
level-to-flow relationship.
Figure 1-1 730 Module Mounted on Sampler
WARNING
The module has not been approved for use in hazardous
locations as defined by the National Electrical Code.
Installation of this module in a hazardous location may
cause fire or explosion resulting in death, personal injury,
or property damage. Before installing any device in a
dangerous location, review safety precautions in your
sampler manual. Check applicable guidelines, codes and
regulations of federal, state, city, and county agencies.