Technika PICTURE FRAME X800 User Manual
Page 7
GETTING STARTED
HANDSET PREPARATION
Remove the protective strip from the battery compartment to activate
the battery.
If the handset behaves erratically or fails to
operate the battery should be replaced.
1: Press the catch at the side of the battery
compartment. Slide out the battery cage
2: Remove the old battery. Place the new bat-
tery in the cage with the polarity as shown.
Close the cage.
There is a risk of fire and burns if the battery
is handled improperly. Do not disassemble,
crush, puncture, short external contacts, or
dispose of in fire or water.
Do not attempt to open or service the battery. Replace only with the
battery designated for this product. Discard used batteries in accord-
ance with recycling regulations in force in your area.
PLACEMENT
Remove the mount from the magnetic clip at the rear of the frame.
Insert it into the attachment hole. Twist the mount clockwise until it
attaches firmly to the frame.
After the mount has been attached, you can set the DPF in the
landscape or portrait orientation.
Place the frame on a firm stable surface where it is unlikely to fall or
get knocked off.
Page 7