Toastmaster 1135CAN - Manual (Page 6)

5.
Using Your Blender
1. Before using your blender for the first time, wash blender
components (1 thru 6) and chopper components (10 thru 12).
Wash components as required after each use.
CAUTION: BLADES ARE SHARP. HANDLE CAREFULLY.
CAUTION: NEVER PLACE BLENDER MOTOR HOUSING OF
APPLIANCE IN WATER OR OTHER LIQUIDS.
2. Place blender motor housing on a dry level surface.
3. Make sure the ON/OFF Switch located at the back of the motor
housing is turned to the OFF position (O), see Figure 5.
4. Invert glass blending jar onto level countertop and assemble
cutting assembly onto bottom of the glass blending jar, making
sure components are securely tightened into place, see Figure 1.
5. Insert glass blending jar aligning the grooves and tabs on collar
until it fits securely into the blender motor housing, see Figure 4.
6. Place food into glass blending jar and cover with cover assembly,
see Figure 3. Always hold onto glass blending jar while blending.
CAUTION: DO NOT ATTEMPT TO OPERATE WITHOUT
COLLAR, BLADES, GASKET, GLASS BLENDING JAR AND COVER
PROPERLY IN PLACE.
7. Plug into 120 V ~ 60 Hz AC outlet.
8. To start the blender, press the ON/OFF switch located at the back of
the blender motor housing to the ON position (I), see Figure 5.
NOTE:
Whenever the blender is switched on, the LOW button
indicator light will be on.
LOW
WHIP LIQUEFY BEAT
AERATE
PUREE PULSE/
ICE CRUSH
BLEND
HIGH
SPREAD GRATE STIR CHOP STOP
SHAKE MIX
FIGURE 8
TMR_1135&1135CAN_IB_25-11-04 11/25/04 3:39 PM Page 5