Re-loop playback, Canceling loop points, Changing the out point – Tascam CD-DJ1 User Manual
Page 18: Half, Adjusting the out point, Restoring the out point, Tempo control, Setting the tempo range, Canceling loop points changing the out point, Half set
1
TASCAM CD-DJ1
5- DJ functions
Tempo control
Use the tempo slider to control playback speed. The
display shows the current tempo adjustment.
Push the slider in the “–” direction to slow the tempo,
and pull it in the “+” direction to speed it up.
Use the
TEMPO
key to change the tempo slider
range. Press the
TEMPO
key to cycle through the fol-
lowing tempo ranges.
±8% (default setting), ±16%, ±32%, ±100%
The new range setting becomes effective after it
flashes on the display for a few seconds.
NOTE
When an attached TT-M1 is turned on, the tempo
slider and TEMPO key do not function. Playback
tempo value is set by the TT-M1 (see "TT-M1 use"
on page ).
Setting the tempo range
Press the
OUT
key during loop playback to change
the OUT point and restart loop playback from the IN
point. The new OUT point is determined according
to the Setup menu OUT KEY setting.
HALF
The new OUT point is set to a point halfway between
the IN point and the OUT point.
SET
The OUT point is set at the location where the
OUT
key is pressed during playback.
ª
ª
Changing the OUT point
Press the
OUT
key while holding down the
SHIFT
key to enable use of the
JOG
dial for editing the OUT
point during loop playback. Turn the dial clockwise
to lengthen the loop (or counterclockwise to shorten
it) during playback until the desired OUT point is
reached. Press the
OUT
key at the desired moment
to set the new OUT point and exit OUT point adjust-
ment mode.
The adjustment will affect the loop playback in real
time.
Adjusting the OUT point
Press the
IN
key while holding down the
SHIFT
key during or after adjustment of the OUT point to
restore the OUT point to its pre-adjustment position
(the display shows
OUT RET).
Restoring the OUT point
Re-loop playback
Press the
RE-LOOP/EXIT
key to restart loop play-
back immediately when it is off but the IN and OUT
points are still set.
Press the
IN
key for immediate playback from the IN
point when it is set (like a
HOT CUE
key).
Cancel the loop (IN and OUT) points with either of
the following actions.
Press the
RE-LOOP/EXIT
key while holding down
the
SHIFT
key. Alternatively, open the CD cover.
The
IN
and
OUT
key lights will turn off when the
loop points are canceled.
Canceling loop points