Tech4o Altimeter Watch - Manual (Page 6)

10 11
measuring unit changes to 1 second and the measuring range is
99 hours, 59 minutes, 59 seconds.
5.1 Stopwatch Mode - Setting
• In stopwatch mode, press and hold the [s/+] button for two
seconds.
• The LAP/INT indicator will flash.
• Both LAP and intermediate settings will record time the same
way, but the way the information is displayed will vary. The
LAP setting will show the just the last lap time when the [s/+]
or [o/o] buttons are pushed and in the stopwatch history. The
Intermediate setting will show the cumulative intermediate times
when the [s/+] or [o/o] buttons are pushed while in stopwatch
history mode.
• Press the [o/-] button to select between Lap and int settings.
Press the [o/o] button to confirm.
5.2 Stopwatch Mode - Using the Stopwatch
How toPress Stopwatch:
• When in stopwatch mode, press the [o/o] button to start the
stopwatch. The top row will now display ------------- and the
bottom row will display the current stopwatch time.
• Press the [o/o] button again to stop the stopwatch. The top and
bottom rows will now display current stopwatch time.
• Press the [o/o] button again to resume the stopwatch. The top
row will now display ------------- and the bottom row will
display the current stopwatch time.
• While the stopwatch is running, users may enter lap/int times
by pressing the [s/+] button. The top row will now display
first lap/int time and the bottom row will display the cumulative
stopwatch time.
• After each successive lap/int time is entered, the top row will
display:
* the cumulative time of all the entered intermediate times if the
int setting was selected or;
* the last lap time if the lap setting was selected.
• The bottom row will display the cumulative stopwatch time.
• When the stopwatch is stopped, press the [o/-] button to
proceed to the stopwatch history mode or press [s/+] to
continues