Topcom ALLURE 270 - Manual (Page 9)

Topcom Allure 270 9
Topcom Allure 270
ENGLIS
H
8.2.4 Setting the Local Prefix (5 digits)
The Local prefix must be set, when you are not allowed to dial out your own area code.
If there is an incoming call, starting with the programmed prefix, the code will not be displayed
and not be stored in the call list.
ex. When 012 is programmed and 0123456789 is the incomming call number, 3456789 is
displayed and stored in the call list.
•
Press for 3 seconds, the display language is shown.
• Press repeatedly until ‘SET LOCAL CODE ‘ is display.
• Use or to select the first digit of the local code (0-9 or ‘-’ to unselect).
• Press confirm the first digit and change next digit.
• Repeat the previous steps for a the 5 digits.
When no local prefix must be set select (- - - - -).
• After confirming the last digit, you will go to the next setting.
If no button is pressed within 10 seconds, the unit will return to standby mode.
8.2.5 Setting the Prefix
If you need to dial out a one digit prefix before a telephone number from the call list or
phonebook, you have to set the Dial Prefix.
•
Press for 3 seconds, the display language is shown.
• Press until ‘PREFIX‘ is display.
• Use or to select the prefix (0-9 or ‘-’ to unselect).
• Press button confirm the prefix.
If no button is pressed within 10 seconds, the unit will return to standby mode.
To dial out the prefix before the selected number out of the call list of phonebook,
press
twice.
8.3 Making a phone call
There are 2 ways to make a phone call :
1.
Enter the telephone number. If needed, you can erase the last digits by pressing .
Pick up the handset or press . The phone number will be dialled automatically.
2. Pick up the receiver or press the Handsfree button . Enter the telephone number.
Note: The call duration timer is shown on the 1e line of the display [mm:ss].